Join Waitlist We will inform you when the product arrives in stock. Just leave your valid email address below.
Email Quantity We won't share your address with anybody else.

Simple Sawhorse Storage

0

I was tired of having my sawhorses just laying around, taking up space so I whipped together this simple sawhorse holder so I could hang them on the wall.

1) I grabbed some scrap 2x4s and cut them to the below lengths. I made the back 18″ so I could screw it into the studs.

2) I took the two 12″ lengths and cut one end at a 5 degree angle (just so there is a slight upwards tilt when they are mounted), then used my Kreg Pocket Jig to make two pockets on both insides, then attached them. Note: Make sure to make the pockets on the end with the angle.

 3) I located the studs on this wall and used 3″ screws to put it in place.

: ) And that’s it. Easy peasy.

Now there will be no more of this….

Share.

Comments are closed.